You are in:
Layde has the following installations and facilities, operated by highly qualified people.
It consists of a 136 m long facility that uses a hydrochloric acid bath to remove the surface oxide layer on the hot rolled coils. After this bath, the surface is completely clean and dry in order to allow an post-process oiling, eliminating the risk of oxidation.
This facility is directly connected to a slitting line where we produce the strips at the final width our customers require.
Our facilities consist of two reversing 650 mm SENDIZIMIR cold rolling mills. Thanks to them we can produce very fine tolerances in all thickness range.
Our manufacturing range is between 0.20 mm. and 3 mm. gauge and between 10 mm. and 650 mm. widths. Inner diameters are 400-508 mm depending on the product.
Our EBNER furnaces are fully automatic, use natural gas and a 100% hydrogen atmosphere that allows equalising the temperature in the whole coil, thereby obtaining identical mechanical characteristics all through it. In addition, contractions and dilatations that cause mark and scratches on the coil surface are avoided with this process.
Thanks to the properties of the hydrogen, the surface we get is extraordinary clean of oils and other waste.
We have skinpass facilities that provide the materials with a slight surface hardening but without the modification of any of the mechanical properties of the material. At the same time, this helps by giving a smooth surface within the roughness our customers would demand.
For the transformation of our precision cold rolled, galvanized, electrozincated and pre-coated coils, we have different slitters and a cut-to-length facilities where we produce the final dimensions our customers require.
Our capabilities are: From 10 mm. to 1,650 mm. width and from 300 mm. to 6,000 mm length.